The issue seems to be with high gain situations.Īny ideas? Sorry for the novel, it's been two weeks of trying to figure the problem out. I've tested the issue with a Fender tube combo, which has noise, but much less. Creation Audio Labs MW1 DI and Reamp box with Korg DT-1 Tuner Guitar Bass, combo. It's still there, but dramatically quieter. This is a great combo for studio recording or live om. Just today I bought a Behringer MicroHD HD400 hum eliminator, which did dramatically attenuate the noise. Additionally, I thought the issue was with the specific Eleven rack I owned, so I exchanged it. This allows you to experiment all you want with the final tone. Once you have the DI, you have the purest form of the performance and can reamp it at any time. The benefit is that you only have to capture the player’s performance once as a DI. I've tested the set up on various outlets throughout the building I work, on various circuits. Reamping is very common these days because it gives you a lot of flexibility. I have both devices plugged into a Furman power conditioner, and have tested with a Livewire power conditioner as well. The moment I bring gain into the picture, noise is introduced. Continue with the installation of the potentiometer and the 1/4 plug and tighten with a wrench to secure them into the unit. Install the toggle switch and use a wrench to firmly tighten the nut. A purpose built adapter, like the ones made by the company called Reamp, or Radial Engineering or A passive direct box (so say some). If I crank the overdrive volume all the way, but keep the gain at zero, no noise. To build a DIY reamp box, start with the XLR jack. If I set the Marshall to its clean channel and crank the volume to max, no noise. 12 Discrete ultra-linear preamps with 75dB of gain on combo XLR jacks for. If I turn down the output levels on the Eleven Rack down to a Mute status, the noise does not turn down. Hi-Z inputs and reamp DI tracks through the special purpose ReAmp outputs. No computer, guitar, or even audio being played necessary. To recreate the issue, I only need to plug my Eleven Rack into the amp, via the Output to Amp into the amp's Input. Upon further research, I've plugged my Eleven Rack into a Marshall solid state practice amp and recreated the same issue. When I attempted to use the reamp feature with a Laney guitar head and 2x12 cabinet, a tremendous amount of broadband white noise came through, rendering the reamping unusable. I'm trying to reamp DI guitar tracks through an amp with it, using the Output to Amp outputs (either 1 or 2). However, I have an issue I can't seem to resolve involving the Eleven Rack. I apologize in advance if my post is not in the correct forum.
0 Comments
Leave a Reply. |